Conditions for Clearing the DTC

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

The ECM/PCM will command the message OFF after one trip in which the diagnostic test has been run and passed.
The history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
The DTC can be cleared by using the scan tool Clear DTC Information function.

DTC P0562

Step	Action	Value(s)	Yes	No
Connector End View Reference: Engine Electrical Connector End Views , Engine Control Module Connector End Views for the 2.2L (L61) engine, or Powertrain Control Module Connector End Views for the 3.5L (L66) engine
1	Did you perform the Diagnostic System Check - Vehicle?	-	Go to Step 3	Go to Diagnostic System Check - Vehicle
2	Install a scan tool. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text. Using the scan tool, observe the specific DTC Information for DTC P0562 until the test runs. Does the scan tool indicate that DTC P0562 has passed this ignition cycle?	-	Go to Testing for Intermittent Conditions and Poor Connections	Go to Step 3
3	Start the engine. Turn Off all accessories. With a scan tool, observe the Ignition 1 parameter in the ECM/PCM data list. Does the scan tool indicate that the Ignition 1 parameter is greater than the specified range?	10.5 V	Go to Step 7	Go to Step 4
4	Measure the voltage at the battery terminals and compare it with the Ignition 1 parameter in the engine control module (ECM)/powertrain control module (PCM) data list. Are the battery voltage and ECM/PCM Ignition 1 readings different by more than the value specified?	0.5 V	Go to Step 5	Go to Charging System Test
5	Test the battery positive voltage circuit of the ECM/PCM for a high resistance. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition?	-	Go to Step 8	Go to Step 6
6	Inspect for poor connections at the harness connector of the ECM/PCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	-	Go to Step 8	Go to Step 7
7	IMPORTANT: The replacement ECM/PCM must be programmed. Replace the ECM/PCM. Refer to Control Module References for replacement, setup, and programming.Did you complete the replacement?	-	Go to Step 8	-
8	Review and record the scan tool Fail Records data. Use the scan tool in order to clear the DTC. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text. Using the scan tool, observe the Specific DTC Information for DTC P0562 until the test runs. Does the scan tool indicate that DTC P0562 failed this ignition?	-	Go to Step 3	System OK