Conditions for Clearing the DTC
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- A current DTC clears when the malfunction is no longer present.
- A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.
DTC B1325
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Control Module References Connector End View Reference: Data Communication Connector End Views |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
9-18 V | Go to Step 3 | Go to Step 4 |
| 3 | Is the DTC set as a current DTC? | - | Go to Step 7 | Go to Testing for Intermittent Conditions and Poor Connections |
| 4 |
|
9-18 V | Go to Step 6 | Go to Step 5 |
| 5 | Test the battery positive voltage circuit for the following:
Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? |
- | Go to Step 9 | Go to Battery Inspection/Test (Side Terminal Battery) or Battery Inspection/Test (Top Post Terminal Battery) |
| 6 | Test the all of ground circuits of the module for an open or high resistance. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
- | Go to Step 9 | Go to Step 7 |
| 7 | Inspect for poor connections at the harness connector of the affected module. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
- | Go to Step 9 | Go to Step 8 |
| 8 | Replace the affected module. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 9 | - |
| 9 | Operate the system in order to verify the repair. Did you find and correct the condition? |
- | System OK | Go to Step 2 |