LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1811 (Fixed And MOVEABLE Windows) >> Repair Instructions >> Rear Side Door Stationary Window Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Door Window Run Channel
    GM928787Courtesy of GENERAL MOTORS CORP.
  1. Install the window run channel seal and fixed glass assembly.
    • Place the seal and fixed glass assembly into the door frame.
    • Place the seal assembly on the door header.
    • Install the fixed glass post upper clip to the door frame.
    • Install the front seal leg to the metal glass run channel.
    • Secure the mushroom retainers at the top ends of the metal glass run channels.
    • Install the seal to the door header flange, starting from the front corner.
      • NOTE: Refer to Fastener Notice .
    • Install the lower fixed glass post bolt.

      Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  2. Install the rear door sound insulator. Refer to Rear Side Door Insulator Replacement .
  3. Install the rear door outer panel. Refer to Rear Side Door Outer Panel Replacement .
  4. Install the rear door window weatherstrip run channel assembly. Refer to Rear Side Door Window Channel Replacement .
  5. Install the rear door applique. Refer to Rear Door Frame Applique Replacement .
  6. Install the rear door window. Refer to Rear Side Door Window Replacement .
scientia non olet · About LEMON Manuals