LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1811 (Fixed And MOVEABLE Windows) >> Repair Instructions >> Rear Door Window Belt Outer Sealing Strip Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Door Window Outer Belt Sealing Strip
    GM943427Courtesy of GENERAL MOTORS CORP.
  1. Align the outer belt seal fastener location with the hole in the door structure and outer panel retaining tabs.
  2. Starting at the rear of the belt seal, push the belt seal down onto the flange until fully seated.
    3. NOTE: Refer to Fastener Notice .
  3. Install the outer belt seal retaining screw.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

scientia non olet · About LEMON Manuals