LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1808 (Power Door Lock System And Release Systems) >> Repair Instructions >> Rear Door Latch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Move the window into the full up position.
  2. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
  3. Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
  4. Disconnect the outside handle rod from the clamshell-style clip.
  5. Disconnect the latch wiring harness clips from the door structure, if equipped.
    6. Fig 1: View Of Rear Door Latch
    GM943624Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the latch wiring pig tail connector from the door wiring harness, if equipped.
  7. Disconnect the inside handle rod and lock rod from the guide clips in the door structure.
    8. Fig 2: Removing/Installing Door Latch Bolts
    GM943633Courtesy of GENERAL MOTORS CORP.
  8. Remove the door latch bolts.
    9. Fig 3: Removing/Installing Rear Door Latch Assembly With The Inside Handle
    GM943659Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the latch wiring pig tail at the latch, if equipped.
  10. Remove the door latch with the inside handle rod and lock rod still attached through the lower opening in the door structure.
    11. Fig 4: Disconnect/Connect Inside Handle Rod & Lock Rod From Latch Assembly
    GM943648Courtesy of GENERAL MOTORS CORP.
  11. Disconnect the inside handle rod and lock rod from the latch assembly.
scientia non olet · About LEMON Manuals