Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Master Cylinder Reservoir

Courtesy of GENERAL MOTORS CORP.

Install the reservoir seals to the master cylinder body.
Install the reservoir to the master cylinder body by pushing the reservoir bayonets straight down into the seals in the master cylinder body.
Install NEW reservoir attachment pins. Ensure that the attachment pins are fully and firmly seated.

Fig 2: Removing/Installing Brake Fluid Level Sensor

Courtesy of GENERAL MOTORS CORP.

Install the brake fluid level sensor. Refer to Master Cylinder Fluid Level Sensor Replacement .

Fig 3: Disconnecting/Connecting Brake Fluid Level Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the low brake fluid level sensor electrical connector.
Fill the master cylinder reservoir. Refer to Master Cylinder Reservoir Filling .
Bleed the brake system. Refer to Hydraulic Brake System Bleeding (Pressure) or Hydraulic Brake System Bleeding (Manual) .