LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1807 (Hydraulic Brake System) >> Repair Instructions >> Brake Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of APP Sensor Harness Connector
    GM927716Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the accelerator pedal assembly electrical connector.
    2. Fig 2: View Of Communication Interface Module (CIM) & Fastener
    GM931404Courtesy of GENERAL MOTORS CORP.
  2. Remove the mounting bolts and reposition the OnStar® module aside, if equipped. Refer to Communication Interface Module Replacement .
    3. Fig 3: Removing/Installing Washer & Retaining Clip To Brake Pedal
    GM926065Courtesy of GENERAL MOTORS CORP.
  3. Remove the retaining clip and washer from the brake pedal.
  4. Release the brake booster pushrod from the brake pedal.
    5. Fig 4: Removing/Installing Stop Lamp Switch
    GM925867Courtesy of GENERAL MOTORS CORP.
  5. Remove the stop lamp switch from the pedal bracket. Refer to Stop Lamp Switch Replacement .
    6. Fig 5: View Of Cruise Brake Switch & Retainer
    GM926071Courtesy of GENERAL MOTORS CORP.
  6. Remove the cruise control release switch, if equipped, from the pedal bracket. Refer to Cruise Release Switch Replacement .
    7. Fig 6: Removing/Installing Brake Pedal Assembly
    GM925895Courtesy of GENERAL MOTORS CORP.
  7. Remove the brake booster mounting nuts.
    8. Fig 7: Removing/Installing Brake Pedal Bracket
    GM931272Courtesy of GENERAL MOTORS CORP.
  8. Remove the brake pedal bracket-to-steering column bracket bolt.
    9. Fig 8: View Of Steering Column Bracket To Cowl Nut
    GM932996Courtesy of GENERAL MOTORS CORP.
  9. Loosen, but do not remove, the steering column bracket to cowl nut.
  10. While simultaneously disengaging the brake pedal bracket pilot bushings from the foam insulation panel, pull the brake pedal assembly back and toward the center of the vehicle.
  11. Remove the brake pedal assembly from the vehicle.
    12. Fig 9: Removing/Installing Accelerator Pedal Assembly
    GM925900Courtesy of GENERAL MOTORS CORP.
  12. Remove the accelerator pedal assembly from the brake pedal bracket. Refer to Accelerator Pedal Position Assembly Replacement in Engine Controls - 2.2L (L61) or Accelerator Pedal Position Sensor Replacement in Engine Controls - 3.5L (L66).
    13. Fig 10: Removing/Installing OnStar J-Nuts & Mounting Bracket Bolts
    GM930264Courtesy of GENERAL MOTORS CORP.
  13. Remove the OnStar® mounting bracket bolts and J-nuts from the brake pedal assembly, if equipped.
scientia non olet · About LEMON Manuals