Diagnostic Aids
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
A lower than normal brake fluid level in the master cylinder may cause the brake fluid level switch to close when the vehicle makes sharp turns or sudden stops. Low brake fluid level may be caused by a brake fluid leak or worn disc brake pads.
Thoroughly inspect connections or circuitry that may cause an intermittent malfunction. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
DTC C0267
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Hydraulic Brake Schematics Connector End View Reference: Hydraulic Brake Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
Go to Step 3 | Go to Diagnostic Aids |
| 3 | Inspect the brake fluid level in the master cylinder reservoir. Refer to Master Cylinder Reservoir Filling . Did you find and correct the condition? |
Go to Step 8 | Go to Step 4 |
| 4 |
|
Go to Step 6 | Go to Step 5 |
| 5 | Replace the brake fluid level switch. Refer to Master Cylinder Fluid Level Sensor Replacement . Did you complete the replacement? |
Go to Step 8 | - |
| 6 |
|
Go to Step 8 | Go to Step 7 |
| 7 | Replace the BCM. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 8 | - |
| 8 |
|
Go to Step 3 | System OK |