Brake System Slow Release
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Brake System Slow Release
| Step |
Action |
Yes |
No |
| DEFINITION: Brake system releases and returns to rest slowly; vehicle motion is hindered by brake system briefly after release of brake pedal. |
| 1 |
Were you sent here from the Hydraulic Brake Symptom table? |
Go to Step 2 |
Go to Diagnostic Starting Point - Hydraulic Brakes |
| 2 |
- Inspect the hydraulic brake system for the following conditions.
- Improper operation of wheel cylinder pistons, if equipped
- Improper operation of caliper pistons
- Internally damaged flexible brake hoses; hindering brake release
- Contaminated brake fluid
- Damaged or improperly operating master cylinder
- Adjust, repair or replace components as necessary. Refer to Hydraulic Brake System Diagnosis .
Did you find and correct a condition? |
Go to Step 6 |
Go to Step 3 |
| 3 |
- Inspect the brake assist system for the following conditions.
- Binding, bent or damaged pedal pushrod, pedal, or pedal bracket
- Damaged or improperly operating vacuum booster, if equipped
- Restricted return hose from hydraulic booster, if equipped
- Damaged or improperly operating hydraulic booster, if equipped
- Adjust, repair or replace components as necessary. Refer to Brake Assist System Diagnosis .
Did you find and correct a condition? |
Go to Step 6 |
Go to Step 4 |
| 4 |
- Inspect the drum brake system, if equipped, for the following conditions.
- Weak or damaged return spring or springs
- Distorted or damaged linings
- Out of round or damaged drum
- Lack of lubrication on backing plate
- Distorted or damaged backing plate
- Adjust, repair or replace components as necessary. Refer to Drum Brake System Diagnosis .
Did you find and correct a condition? |
Go to Step 6 |
Go to Step 5 |
| 5 |
- Inspect the disc brake system for the following conditions.
- Damaged or excessively worn caliper hardware and/or lining hardware
- Distorted or damaged linings
- Lack of lubrication or excessive corrosion on metal to metal contact surfaces
- Bent or damaged caliper or mounting component
- Adjust, repair or replace components as necessary. Refer to Disc Brake System Diagnosis .
Did you find and correct a condition? |
Go to Step 6 |
Go to Diagnostic Starting Point - Hydraulic Brakes |
| 6 |
- Install or connect components that were removed or disconnected during diagnosis.
- Road test the vehicle in order to confirm proper operation. Refer to Brake System Vehicle Road Test .
Is the condition still present? |
Go to Step 2 |
System OK |