LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1807 (Hydraulic Brake System) >> Diagnostic Information and Procedures >> Brake Pulsation

Brake Pulsation

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Brake Pulsation

Step Action Yes No
DEFINITION: Fluctuation or pulsation is felt through the brake pedal, steering wheel, seat, floor, and/or in the vehicle ONLY when braking.
1 Were you sent here from the Hydraulic Brake Symptom table? Go to Step 2  Go to Diagnostic Starting Point - Hydraulic Brakes 
2
  1. Inspect the disc brake system for the following conditions.
    • Excessive thickness variation of rotor friction surfaces
    • Excessive assembled lateral runout (LRO) of rotor friction surfaces
    • Hard spots, heat checks, blueing discoloration of rotor friction surfaces; possibly due to brake drag
    • Excessive corrosion of rotor friction surfaces; including red, gray or black oxidation
    • Loose, damaged or missing caliper or lining hardware
    • Bent or damaged caliper or mounting component
    • Excessive LRO of wheel hub/axle flange; due to damage and/or loose or excessively worn bearings
  2. Adjust, repair or replace components as necessary. Refer to Disc Brake System Diagnosis .
Did you find and correct a condition?
Go to Step 4  Go to Step 3 
3
  1. Inspect the drum brake system, if equipped, for the following conditions.
    • Out of round or damaged drum
    • Excessive radial runout of drum friction surface
    • Hard spots, heat checks, blueing discoloration of drum friction surface; possibly due to brake drag
    • Bent or damaged drum
    • Excessive radial runout of wheel hub/axle flange; due to damage and/or loose or excessively worn bearings
  2. Adjust, repair or replace components as necessary. Refer to Drum Brake System Diagnosis .
Did you find and correct a condition?
Go to Step 4  Go to Diagnostic Starting Point - Hydraulic Brakes 
4
  1. Install or connect components that were removed or disconnected during diagnosis.
  2. Road test the vehicle in order to confirm proper operation. Refer to Brake System Vehicle Road Test .
Is the condition still present?
Go to Step 2  System OK