LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1805 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Front Side Door Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front fender. Refer to Front Fender Replacement .
    2. CAUTION: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.
    Fig 1: View Of Front Door
    GM941645Courtesy of GENERAL MOTORS CORP.
  2. Remove the front door outer panel. Refer to Front Side Door Outer Panel Replacement .
  3. Remove the front door sound insulator. Refer to Front Side Door Insulator Replacement .
  4. Disconnect all of the wiring harness connectors inside the door.
  5. Disengage the wiring harness grommet from door and remove the harness.
  6. Remove the front door check link. Refer to Front Side Door Check Link Replacement .
  7. Support the door.
  8. Using a soft marker, mark around the outside of the hinge for installation purposes.
  9. Remove the door hinge to body bolts.
  10. With an assistant remove the front door from the vehicle.
scientia non olet · About LEMON Manuals