Test Description
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the step numbers on the diagnostic table.
- 2: This step will determine if the rear wiper relay is internally shorted to battery voltage. Once you have disconnected the relay, you should be able to clear DTC B3723 with no recurrence. It is, however, normal for DTC B3722 to set while the relay is disconnected.
- 3: This step will determine if the rear wiper relay control circuit is shorted to battery voltage, or if the BCM is at fault.
DTC B3723
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Wiper/Washer Schematics Connector End View Reference: Master Electrical Component List |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
IMPORTANT:
DTC B3722 may set as a result of disconnecting the REAR WIPER Relay.
|
Go to Step 5 | Go to Step 3 |
| 3 | Test the rear wiper relay control circuit for a short to battery. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 6 | Go to Step 4 |
| 4 | Replace the body control module (BCM). Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 6 | - |
| 5 | Replace the rear wiper relay. Refer to Relay Replacement (Attached to Wire Harness)
or Relay Replacement (Within an Electrical Center)
. Did you complete the replacement? |
Go to Step 6 | - |
| 6 |
|
Go to Step 2 | System OK |