Diagnostic Aids
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect wiring harness for damage. Inspect for broken or chaffed insulation.
- If fault is suspected to be intermittent, wiggling harness wiring may help in locating fault.
- Inspect for poor connection at the BCM. Inspect harness connectors for backed out terminals, improper terminal mating, broken connector locks, improperly formed or damaged terminals and poor terminal-to-wire connection, terminal is crimped over wire insulation and not conductors.
DTC B3702
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Wiper/Washer Schematics Connector End View Reference: Master Electrical Component List |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
0.4 V | Go to Step 3 | Go to Diagnostifc Aids for this test |
| 3 |
|
4.5 V | Go to Step 6 | Go to Step 4 |
| 4 |
|
- | Go to Step 5 | Go to Step 7 |
| 5 | Repair a short to ground in the windshield wiper switch signal circuit. Refer to Wiring Repairs
or Connector Repairs
. Did you complete the repair? |
- | Go to Step 8 | - |
| 6 | Replace the windshield wiper washer switch. Refer to Turn Signal Multifunction Switch Replacement
. Did you complete the replacement? |
- | Go to Step 8 | - |
| 7 | Replace the BCM. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 8 | - |
| 8 |
|
- | Go to Step 2 | System OK |