LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1801 (Frame And Underbody) >> Repair Instructions >> Frame Cushion or Insulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the frame insulator opening.
  2. Apply thin coat of rubber lubricant GM P/N 1051717 (Canadian P/N 5728223), or equivalent to the inside of the frame insulator opening.
  3. Apply thin coat of rubber lubricant GM P/N 1051717 (Canadian P/N 5728223), or equivalent to the inside of the frame insulator.
    4. IMPORTANT: The frame insulator tabs should be aligned horizontally or left to right on the vehicle and the recessed area should be aligned vertically or front to back on the vehicle.
    Fig 1: Installing Frame Insulator
    GM1523339Courtesy of GENERAL MOTORS CORP.
  4. Install the frame insulator to the front frame opening with the alignment tabs facing up.
    5. Fig 2: Installing Frame Insulator Using CH-47672
    GM1523340Courtesy of GENERAL MOTORS CORP.
  5. Use the CH-47672  to install the frame insulator to the frame. See Special Tools .
  6. Remove the CH-47672  from the frame. See Special Tools .
  7. Install the frame to the vehicle. Refer to Frame Replacement (L61)  or Frame Replacement (L66) .
scientia non olet · About LEMON Manuals