LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1800 (Exterior Trim) >> Repair Instructions >> Rocker Panel Molding Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rocker Panel Molding
    GM929252Courtesy of GENERAL MOTORS CORP.
  1. Position the rocker panel molding to the vehicle.
  2. Slide the rocker panel molding rearward to lock the molding into place.
  3. Install the push-in retainers that attach the front and rear wheelhouse liners to the rocker panel molding.
  4. Install the push-in retainers along the bottom of the rocker panel molding.
scientia non olet · About LEMON Manuals