Headlamps Flash to Pass Inoperative

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Step	Action	Yes	No
Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Place the headlamp switch in the HEADLAMP position. Place the multifunction lever in the FLASH TO PASS position. Do the high beam headlamps illuminate?	Go to Testing for Intermittent Conditions and Poor Connections	Go to Step 3
3	Test for an open or high resistance in the flash to pass ground circuit of the headlamp switch. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition?	Go to Step 6	Go to Step 4
4	Inspect for poor connections at the harness connector of the headlamp switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 6	Go to Step 5
5	Replace the headlamp switch. Refer to Turn Signal Multifunction Switch Replacement . Did you complete the repair?	Go to Step 6	-
6	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3