LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1798 (Interior Trim And Paneling) >> Repair Instructions >> Rear Side Door Trim Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Window Regulator Handle
    GM977871Courtesy of GENERAL MOTORS CORP.
  1. Position the trim panel over the top of the door and push downward to engage the trim panel hooks to the door structure.
    2. Fig 2: View Of Side Door Trim Panel
    GM977941Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the screw located at the bottom of the door trim panel

    Tighten:  Tighten the screw to 2.5 N.m (22 lb in)

  3. Install the fasteners located behind the pull handle escutcheon.

    Tighten:  Tighten the screw to 2.5 N.m (22 lb in)

  4. Snap the escutcheon into place.
  5. Install the inside door handle. Refer to Door Inside Handle Replacement .
scientia non olet · About LEMON Manuals