LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1798 (Interior Trim And Paneling) >> Repair Instructions >> Rear Quarter Lower Trim Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the carpet retainer. Refer to Rear Carpet Retainer Replacement .
  2. Remove the lock pillar garnish molding. Refer to Lock Pillar Upper Garnish Molding Replacement .
  3. Remove the rear upper trim molding. Refer to Rear Window Upper Molding Replacement .
  4. Fig 1: View Of Rear Lower Trim Panel
    GM899135Courtesy of GENERAL MOTORS CORP.
  5. Remove the finish molding from the rear upper trim.
  6. Fig 2: Load Floor Storage Bin
    GM977535Courtesy of GENERAL MOTORS CORP.
  7. On the driver side, remove the fasteners from the load floor storage bin.
  8. On the driver side, remove the load floor storage bin.
  9. Fig 3: Cargo Hooks
    GM980988Courtesy of GENERAL MOTORS CORP.
  10. Remove the cargo hooks.
  11. Fig 4: Rear Wheel Quarter Trim Panel & Attaching Clip
    GM965660Courtesy of GENERAL MOTORS CORP.
  12. On the driver side, disconnect the accessory wire harness.
  13. Pull at the clip locations to disengage the side trim panel from the vehicle.