LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1798 (Interior Trim And Paneling) >> Repair Instructions >> Center Pillar Upper Garnish Molding Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Belt Height Adjuster Cover
    GM1650910Courtesy of GENERAL MOTORS CORP.
  1. Unsnap the height adjuster cover.
  2. Remove the D-ring bolt.
  3. Remove the shoulder belt from the center pillar.
    4. Fig 2: Removing Fastener Cover From Center Pillar
    GM987721Courtesy of GENERAL MOTORS CORP.
  4. Remove the fastener cover from the center pillar garnish molding by inserting a small flat-bladed tool in the gap at the forward vertical side of the cover.
  5. Remove the center pin of the garnish molding fastener by using needle-nose pliers.
  6. Starting at the top, gently pull on the garnish molding to disengage the attaching clips.
    7. Fig 3: Removing/Installing Fastener Cover To The Garnish Molding
    GM977195Courtesy of GENERAL MOTORS CORP.
  7. Remove the garnish molding by sliding the molding up and disengaging the inside clips from the lower garnish molding.
scientia non olet · About LEMON Manuals