LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1797 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Passenger Presence System Replacement - Front (without Heated Seat)

Inflatable Restraint Passenger Presence System Replacement - Front (without Heated Seat)

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Inflatable Restraint Passenger Presence System - Front (without Heated Seat)
GM1554769Courtesy of GENERAL MOTORS CORP.
Inflatable Restraint Passenger Presence System Replacement - Front (without Heated Seat)

Callout Component Name
CAUTION: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.
CAUTION: To avoid personal injuries, re-zero the passenger presence system whenever you remove or replace the seat cushion or trim. Failure to do so may cause the system to malfunction.
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .

Preliminary Procedure

  1. Remove the front bucket seat. Refer to Front Seat Replacement - Bucket .
  2. Remove the recliner handle. Refer to Driver Seat Recliner Handle and Passenger Seat Recliner Handle Replacement (Non-Fold Flat) .
  3. Remove the seat cushion outer trim panel. Refer to Front Seat Cushion Outer Trim Panel Replacement (2-Way) or Front Seat Cushion Outer Trim Panel Replacement (4-Way) or Front Seat Cushion Outer Trim Panel Replacement (6-Way) .
  4. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Rezeroing .
  5. Refer to Control Module References for programming and setup information.
1 Cover, Passenger Seat Cushion
Refer to Front Seat Cushion Cover and Pad Replacement .
2 Sensor, Inflatable Restraint Passenger Presence System
Tip: 
  1. Note the routing of the wiring harness and connector location for installation.
  2. Disconnect the electrical connector.
3 Pad, Passenger Seat Cushion
4 Screw, Inflatable Restraint Passenger Presence Module (Qty: 3)

Tighten:  2 N.m (18 lb in)

5 Module, Inflatable Restraint Passenger Presence Module
Tip:  Remove module from bracket to replace.