Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disconnecting/Connecting Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector to the door jamb switch.
Position the outer trim panel.

Fig 2: Left I/P Outer Trim Cover

Courtesy of GENERAL MOTORS CORP.

Push to install the panel.

Fig 3: View Of Knee Bolster (Filler Panel) & Screws

Courtesy of GENERAL MOTORS CORP.

Position the steering column filler panel.
Push to install the filler panel.

NOTE: Refer to Fastener Notice .

Install the screws to the steering panel filler panel.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).