LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1795 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Lumbar Support Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Lumbar Actuator
    GM981618Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the lumbar actuator to the seat cushion frame with screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    2. Fig 2: View Of Lumbar Knob
    GM981575Courtesy of GENERAL MOTORS CORP.
  2. Install the lumbar knob.
  3. Install the lumbar cable in the actuator:
    1. Pull back on the lumbar cable sleeve.
    2. Install the barrel end of the cable from the lumbar actuator.
    3. Adjust the knob to ensure that the cable is properly installed.
  4. Install the front seat. Refer to Front Seat Replacement - Bucket .
scientia non olet · About LEMON Manuals