LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1795 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Front Seat Replacement - Bucket >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Positioning Seat In Vehicle & Engaging The Front Adjuster Hooks
    GM987349Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: This step must be performed to assure proper timing of the adjusters.
  1. Adjust the seat adjuster tracks to the fully rearward position.
  2. Position the seat in the vehicle and engage the front adjuster hooks in the floor pan.
    3. Fig 2: Disconnecting/Connecting Heat Module Electrical Connector
    GM981887Courtesy of GENERAL MOTORS CORP.
  3. Position the seat in the fully forward position to expose the rear bolt locations.
  4. Connect the seat electrical connectors.
    5. Fig 3: Removing/Installing Front Seat Adjuster Bolts
    GM981927Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  5. Install the seat adjuster bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  6. Install the shoulder belt webbing in the quick disconnect anchor.
  7. Inspect the front seat belt for proper operation.
    8. CAUTION: To avoid personal injuries, re-zero the passenger presence system whenever you remove or replace the seat cushion or trim. Failure to do so may cause the system to malfunction.
  8. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Programming and Setup .
scientia non olet · About LEMON Manuals