LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1795 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Front Seat Lumbar Support Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Twisting Lower Portion Of Lumbar Unit
    GM987938Courtesy of GENERAL MOTORS CORP.
  1. Install the lumbar unit to the lower portion of the seat back cross wire.
    2. Fig 2: Twisting Upper Portion Of Lumbar Unit
    GM987798Courtesy of GENERAL MOTORS CORP.
  2. Position the lumbar unit to the upper portion of the cross wire. Using a flat-bladed tool, twist the lumbar unit over the cross wire assembly.
    3. Fig 3: View Of Lumbar Cable End
    GM987766Courtesy of GENERAL MOTORS CORP.
  3. Compress the lumbar unit and connect the cable barrel end to the lumbar unit.
  4. Adjust the lumbar unit to ensure proper operation.
  5. Install the seat back pad and cover. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement (Fold Flat)  or Front Seat Back Cushion Cover and Cushion Pad Replacement (Non-Fold Flat) .
scientia non olet · About LEMON Manuals