Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Positioning Seat Cushion Pad To The Frame

Courtesy of GENERAL MOTORS CORP.

Position the seat cushion pad to the frame.
Engage the hook and loop retainers by pressing down on the retainers.
Engage the J-strip at the rear of the cushion cover to the seat pan.
On vehicles with a J-hook design, connect the J-hook retainers.

Fig 2: View Of Drawstring Clips

Courtesy of GENERAL MOTORS CORP.

On vehicles with a drawstring design, connect the drawstring clips.

Fig 3: Removing/Installing Frame Bolts

Courtesy of GENERAL MOTORS CORP.

Position the seat cushion pan over the seat adjusters.

NOTE: Refer to Fastener Notice ,

Install the frame bolts.
Tighten: Tighten the bolts to 12 N.m (9 lb ft).

Fig 4: Disconnecting/Connecting Heat Module Electrical Connector

Courtesy of GENERAL MOTORS CORP.

For vehicles with heated seats connect the heat module electrical connector.
If the seat is equipped with a lumbar support, perform the following procedure:
1. Pull the lumbar cable sleeve forward.
2. Using a sharp-bladed tool, make a small slit where the lumbar actuator meets the cover.
3. Install the lumbar knob by pushing firmly.
4. Adjust the lumbar knob to ensure that the lumbar is operating correctly.
Install the front seat into the vehicle. Refer to Front Seat Replacement - Bucket .

CAUTION: To avoid personal injuries, re-zero the passenger presence system whenever you remove or replace the seat cushion or trim. Failure to do so may cause the system to malfunction.

Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Programming and Setup .