Servicing Information

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 1999 Oldsmobile Bravada, 1999 GMC Sonoma, 1999 GMC Jimmy, 1999 GMC Envoy, and 1999 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Replace all components included in the repair kits.
Lubricate the parts as specified.
Do not use lubricated shop air on the brake parts. Shop air can damage the rubber components.
If necessary, bleed all or part of the brake system after any hydraulic component has been removed or disconnected.
Replace brake pads in axle sets only.
The torques specified are for dry, unlubricated fasteners.
Perform service operations on a clean bench. Verify that the bench is free from mineral oil and other contaminants.
Use extreme care when doing any work around antilock components in order to prevent damage or misalignment.
Pump the brake pedal several times in order to make sure it is firm prior to moving the vehicle. Do not move the vehicle until a firm pedal has been obtained. Check the brake fluid level in the master cylinder after pumping the brakes.