LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1785 (Wiring Systems (General Information)) >> Repair Instructions >> Relay Replacement (Within an Electrical Center) >> Removal Procedure >> Notes

Removal Procedure: Notes

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the electrical center cover.
  2. Locate the relay. Refer to ELECTRICAL CENTER IDENTIFICATION VIEWS  to locate the electrical center where the relay exists.
    IMPORTANT:
    • Always note the orientation of the relay.
    • Ensure that the electrical center is secure, as not to put added stress on the wires or terminals.
  3. Using the J 43244 (1) position the tool on opposing corners of the relay (2).
    NOTE: Use J43244 to pull the relay straight out from the electrical center terminals. The use of pliers or a flat bladed tool could damage the electrical center.
  4. Remove the relay (2) from the electrical center.
    Fig 1: Removing Relay From Electrical Center Using Special Tool
    G03383664Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals