LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1780 (Rear Wheel Steering System) >> Repair Instructions >> Steering Gear Actuator Boot Shield Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When lifting the vehicle do not allow the jack to touch the rear steering gear. If the jack touches the rear steering gear you may damage the gear or the rack and pinion boots. If the boots are damaged replace the rack and pinion boot.
  1. Raise the vehicle. Refer to JACKING AND LIFTING .
  2. Unsnap the locking tabs on the rack and pinion boot protector (1).
  3. Remove the rack and pinion boot protector (1) from the rack and pinion boot (2).
    Fig 1: Rack & Pinion Boot & Protector
    G01479947Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals