LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1780 (Rear Wheel Steering System) >> Repair Instructions >> Steering Gear Actuator Boot Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rack and pinion boot protector (1) to the rack and pinion boot (2).
  2. Snap the locking tabs together on the rack and pinion boot protector.
  3. Lower the vehicle.
    Fig 1: Rack & Pinion Boot & Protector
    G01479948Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals