LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1778 (Rear Wheel Steering System) >> Repair Instructions >> Steering Gear Actuator Boot Shield Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When lifting the vehicle do not allow the jack to touch the rear steering gear. If the jack touches the rear steering gear you may damage the gear or the rack and pinion boots. If the boots are damaged replace the rack and pinion boot.
  1. Raise the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Unsnap the locking tabs on the rack and pinion boot protector (1).
  3. Remove the rack and pinion boot protector (1) from the rack and pinion boot (2).
    Fig 1: Removing Rack/Pinion Boot Protector From Rack/Pinion Boot
    G01455314Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals