LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1778 (Rear Wheel Steering System) >> Repair Instructions >> Steering Gear Actuator Boot Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rack and pinion boot protector (1) to the rack and pinion boot (2).
  2. Snap the locking tabs together on the rack and pinion boot protector.
  3. Lower the vehicle.
    Fig 1: Installing Rack/Pinion Boot Protector From Rack/Pinion Boot
    G01455315Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals