LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1776 (Engine Cooling System) >> Repair Instructions >> Coolant Recovery Reservoir Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the coolant recovery reservoir.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the retaining bolt to the front wheel house panel.

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

    Fig 1: Removing/Installing Coolant Recovery Reservoir Hoses & Bracket Bolt
    GM769224Courtesy of GENERAL MOTORS CORP.
  3. Secure the coolant recovery reservoir to the wheel house panel with the nut.

    Tighten:  Tighten the nut to 10 N.m (88 lb in).

  4. Install the coolant hose to the coolant recovery reservoir (2).
  5. Install the accumulator to the coolant recovery reservoir and secure the accumulator with the bracket and the bolt (1).
  6. Install the air cleaner assembly.
scientia non olet · About LEMON Manuals