LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1773 (Frame & Underbody) >> Repair Instructions >> Transmission Support Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the fuel tank shield. Refer to Fuel Tank Shield Replacement (Trailblazer, Envoy)  or Fuel Tank Shield Replacement (Trailblazer EXT, Envoy XL) .
  3. If vehicle is a short wheel base (Trailblazer, Envoy, Bravada), remove the evaporative emission (EVAP) canister from its mounting bracket. Do not disconnect the canister lines. Refer to EVAP CANISTER in Engine Controls.
  4. Support the transmission with a transmission jack.
    5. Fig 1: View Of Transmission Mount To Transmission Support
    GM744176Courtesy of GENERAL MOTORS CORP.
  5. Remove the transmission mount to the transmission support retaining nuts.
    6. Fig 2: Removing Lower Transmission Support To Frame Mounting Bolts
    GM745746Courtesy of GENERAL MOTORS CORP.
  6. Remove the lower transmission support to the frame mounting bolts.
    7. Fig 3: Removing Upper Transmission Support To Frame Mounting Bolts
    GM752138Courtesy of GENERAL MOTORS CORP.
  7. Remove the upper transmission support to the frame mounting bolts.
  8. Remove the transmission support from the frame.
scientia non olet · About LEMON Manuals