LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1773 (Frame & Underbody) >> Repair Instructions >> Transmission Support Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Transmission Support To Frame
    GM752138Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission support to the frame.
    2. NOTE: Refer to Fastener Notice in CAUTIONS & NOTICES .
  2. Install the upper transmission support to the frame mounting bolts.

    Tighten:  Tighten the upper transmission support to the frame mounting bolts to 80 N.m (59 lb ft).

    3. Fig 2: Installing Lower Transmission Support To Frame Mounting Bolts
    GM745746Courtesy of GENERAL MOTORS CORP.
  3. Install the lower transmission support to the frame mounting bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  4. Lower the transmission onto the transmission support.
    5. Fig 3: View Of Transmission Mount To Transmission Support
    GM744176Courtesy of GENERAL MOTORS CORP.
  5. Install the transmission mount to the transmission support retaining nuts.

    Tighten:  Tighten the transmission mount to the transmission support retaining nuts to 46 N.m (35 lb ft).

  6. If vehicle is a short wheel base (TrailBlazer, Envoy, Bravada), install the evaporative emission (EVAP) canister. Refer to EVAP CANISTER in Engine Controls.
  7. Install the fuel tank shield. Refer to Fuel Tank Shield Replacement (TrailBlazer, Envoy)  or Fuel Tank Shield Replacement (TrailBlazer EXT, Envoy XL) .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals