LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1773 (Frame & Underbody) >> Repair Instructions >> Fuel Tank Shield Replacement (Trailblazer, Envoy) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Fuel Tank Shield
    GM730787Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel tank shield to the frame.
    2. NOTE: Refer to Fastener Notice in CAUTIONS & NOTICES .
  2. Install the fuel tank shield to the frame retaining bolts and nut.

    Tighten:  Tighten the fuel tank shield to the frame retaining bolts and nut to 25 N.m (18 lb ft).

    3. Fig 2: View Of Frame Brace
    GM759221Courtesy of GENERAL MOTORS CORP.
  3. Install the frame brace.
  4. Install the frame brace mounting bolts.

    Tighten:  Tighten the frame brace mounting bolts to 50 N.m (37 lb ft).

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals