Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Properly support the frame when you change the body mounts. If only one mount is changed, lower the entire side on which the mount in placed in order to provide clearance for the mount.

Raise the vehicle slightly on a hoist. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
Place jack stands under the body on the side of the vehicle that the mounts will be placed.

Fig 1: Removing Body Mount Bolt Retainer And Lower Cushion

Courtesy of GENERAL MOTORS CORP.

Remove the body mount bolt, retainer, and lower cushion (1) from the radiator support.

Fig 2: View Of Frame Lower Cushions

Courtesy of GENERAL MOTORS CORP.

Remove the body mount bolts, retainers, and lower cushions (1) from the 5 other mount locations.
Lower the hoist enough in order to leave the body supported by the jack stands.
Remove the upper cushions (2) from the vehicle.