LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1773 (Frame & Underbody) >> Repair Instructions >> Engine Protection Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Engine Shield
    GM687450Courtesy of GENERAL MOTORS CORP.
  1. Install the engine shield.
    2. NOTE: Refer to Fastener Notice in CAUTIONS & NOTICES .
  2. Install the engine shield mounting bolts.

    Tighten:  Tighten the engine shield mounting bolts to 25 N.m (18 lb ft).

  3. Lower the vehicle.
scientia non olet · About LEMON Manuals