LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1773 (Frame & Underbody) >> Repair Instructions >> Crossmember Replacement - Rear Steering Gear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear steering gear crossmember to the vehicle.
    Fig 1: Removing Rear Steering Gear Crossmember
    GM759216Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to Fastener Notice in CAUTIONS & NOTICES .
  2. Install the rear steering gear crossmember mounting bolts.

    Tighten:  Tighten the rear steering gear crossmember mounting bolts to 50 N.m (37 lb ft).

  3. Install the front steering gear crossmember rear mounting bolts.

    Tighten:  Tighten the front steering gear crossmember mounting bolts to 50 N.m (37 lb ft).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals