LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1773 (Frame & Underbody) >> Repair Instructions >> Crossmember Replacement - Front Steering Gear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Steering Gear Crossmember Mounting Bolts
    GM687452Courtesy of GENERAL MOTORS CORP.
  1. Install the steering gear crossmember.
    2. NOTE: Refer to Fastener Notice in CAUTIONS & NOTICES .
  2. Install the steering gear crossmember mounting bolts.

    Tighten:  Tighten the steering gear crossmember mounting bolts to 50 N.m (37 lb ft).

    3. Fig 2: Installing Rear Lower Control Arm Bracket To Frame Mounting Bolts
    GM899003Courtesy of GENERAL MOTORS CORP.
  3. Install the rear lower control arm bracket to frame mounting bolts.

    Tighten:  Tighten the rear lower control arm bracket to frame mounting bolts to 240 N.m (177 lb ft).

    4. Fig 3: Removing/Installing Engine Shield
    GM687450Courtesy of GENERAL MOTORS CORP.
  4. Install the engine shield.
  5. Install the engine shield mounting bolts.

    Tighten:  Tighten the engine shield mounting bolts to 25 N.m (18 lb ft).

  6. Lower the vehicle.
scientia non olet · About LEMON Manuals