Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Assist Step Support Brackets

Courtesy of GENERAL MOTORS CORP.

Install the assist step pad to the assist step, ensuring that the fasteners (2) are fully seated.
Position the assist step to the vehicle.
NOTE: Refer to Fastener Notice in CAUTIONS & NOTICES .

Install the nuts (1) that retain the assist step to the assist step support brackets.

Tighten: Tighten the nuts to 25 N.m (18 lb ft).
Lower the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .