LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1772 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Use R-12 refrigerant oil (mineral) to lubricate O-rings. Use of R-134a (PAG) oil will cause premature corrosion of fitting joints.
  1. Lubricate pressure sensor O-ring with mineral oil. Refer to O-Ring Replacement .
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Hand start pressure sensor onto the pressure port taking care not to pinch the O-ring and tighten.

    Tighten:  Tighten the pressure sensor to 10 N.m (89 lb in).

  3. Connect the engine harness connector to the pressure sensor.
scientia non olet · About LEMON Manuals