LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1771 (Engine Exhaust) >> Repair Instructions >> Exhaust Heat Shield Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Positioning Shield Onto Vehicle
    GM927081Courtesy of GENERAL MOTORS CORP.
  1. Position the shield to the vehicle, aligning the front hole stud. Place the rear of the shield under the rear shield and against the underbody.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the nut and tighten.

    Tighten:  Tighten the heat shield-to-underbody nut to 10 N.m (89 lb ft).

  3. Install the rivets.
    4. Fig 2: View Of Hanger From Rubber Isolators
    GM926825Courtesy of GENERAL MOTORS CORP.
  4. Install the manifold exhaust pipe. Refer to Exhaust Manifold Pipe Replacement (L81)  or Exhaust Manifold Pipe Replacement (L61) .
scientia non olet · About LEMON Manuals