LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (Automatic Transaxle Servicing) >> Removal & Installation >> Transaxle Mount Assembly (Side) >> Removal

Transaxle Mount Assembly (Side): Removal

WARNING: This page is about a different car, the 2003 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle.
  2. Remove the left front wheel and tire assembly.
  3. Remove the left front splash shield.
  4. Install a jackstand and a block of wood to support the transaxle.
  5. Remove the mount thru-bolt from the transaxle mount.
  6. Unscrew the rear upper mount bolt and leave in place.
  7. Remove the remaining 3 mount bolts.
  8. Remove the mount.
scientia non olet · About LEMON Manuals