LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (Automatic Transaxle Servicing) >> Removal & Installation >> Transaxle Mount Assembly (Side) >> Installation

Transaxle Mount Assembly (Side): Installation

WARNING: This page is about a different car, the 2003 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Transfer the rear upper mount to the new mount.
  2. Position the mount and start the rear upper bolt into the threads.
  3. Install the remaining 3 bolts.
  4. Tighten all 4 of the mount bolts to specification. See TORQUE SPECIFICATIONS  .
  5. Install the mount thru-bolt. Tighten the mount thru-bolt to specification. See TORQUE SPECIFICATIONS  .
  6. Remove the jackstand and the wood block.
  7. Install the left splash shield.
  8. Install the left tire and wheel assembly.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals