LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (Automatic Transaxle Servicing) >> Removal & Installation >> Low/Reverse Servo Assembly >> Removal

Low/Reverse Servo Assembly: Removal

WARNING: This page is about a different car, the 2003 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transaxle oil pan and filter. See DRAINING & REFILLING  under REMOVAL & INSTALLATION.
  2. Remove the oil feed pipes. See OIL FEED PIPES  .
  3. Remove the 3 low-reverse band servo cover bolts, the servo and the spring. See Fig 1 .
  4. Disassemble, clean and inspect the low/reverse servo assembly.
Fig 1: Removing & Installing Low/Reverse Servo
G00088296Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals