LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1763 (Front Suspension) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Brake Rotor
    GM931367Courtesy of GENERAL MOTORS CORP.
  1. Remove the front brake rotor. Refer to FRONT BRAKE ROTOR in Disc Brakes.
    2. Fig 2: Front Wheel Speed Sensor
    GM926677Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the wheel speed sensor electrical connector, if equipped.
    3. Fig 3: Wheel Speed Sensor Electrical Connector & Connector Bracket
    GM931451Courtesy of GENERAL MOTORS CORP.
  3. Remove the wheel speed sensor electrical connector form the connector bracket.
    4. Fig 4: Front Wheel Drive Shaft Spindle & Nut
    GM933045Courtesy of GENERAL MOTORS CORP.
  4. Remove the front wheel drive shaft spindle nut.
    5. Fig 5: View Of Wheel Bearing/Hub Assembly & Mounting Bolts
    GM933099Courtesy of GENERAL MOTORS CORP.
  5. Support the wheel drive shaft with heavy mechanic's wire or equivalent.
  6. Remove and discard the wheel bearing/hub mounting bolts.
  7. Remove the wheel bearing/hub assembly from the steering knuckle.
scientia non olet · About LEMON Manuals