LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1763 (Front Suspension) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Bearing/Hub Assembly & Mounting Bolts
    GM933099Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel bearing/hub assembly to the steering knuckle.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the wheel bearing/hub mounting bolts.

    Tighten:  Tighten the bolts to 130 N.m (96 lb ft).

    3. Fig 2: Front Wheel Drive Shaft Spindle & Nut
    GM933045Courtesy of GENERAL MOTORS CORP.
  3. Install the wheel drive shaft spindle nut.

    Tighten:  Tighten the nut to 205 N.m (151 lb ft).

    4. Fig 3: Wheel Speed Sensor Electrical Connector & Connector Bracket
    GM931451Courtesy of GENERAL MOTORS CORP.
  4. Install the wheel speed sensor electrical connector to the mounting bracket, if equipped.
    5. Fig 4: Front Wheel Speed Sensor
    GM926677Courtesy of GENERAL MOTORS CORP.
  5. Connect the wheel speed sensor electrical connector.
    6. Fig 5: Front Brake Rotor
    GM931367Courtesy of GENERAL MOTORS CORP.
  6. Install the front brake rotor. Refer to FRONT BRAKE ROTOR in Disc Brakes.
scientia non olet · About LEMON Manuals