LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1763 (Front Suspension) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Stabilizer Bar Clamps, Bushings & Bolts
    GM929945Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer bar clamps and bushings to the stabilizer bar.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the stabilizer bar clamp to cradle bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  3. Lower the vehicle.
scientia non olet · About LEMON Manuals