LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1760 (Bumpers) >> Repair Instructions >> License Bracket Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: License Bracket Replacement
    GM929440Courtesy of GENERAL MOTORS CORP.
  1. Remove the license plate screws and the license plate.
  2. Install a drill stop on drill bit in order to ensure that the bit does not penetrate the front fascia more than 13 mm (0.5 in).
  3. Drill out the rivets attaching the license plate bracket to the front fascia.
  4. Remove the license plate bracket.
scientia non olet · About LEMON Manuals