LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1760 (Bumpers) >> Repair Instructions >> License Bracket Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. If this is a first-time installation, complete the following steps:
    1. Install a drill stop on a 5 mm (13/64 in) drill bit in order to ensure that the bit does not penetrate the front fascia more than 13 mm (0.5 in).
    2. Align the two upper license plate bracket mounting holes, that are labeled Saturn VUE, with the dimples in the front fascia.
    3. Using the license plate bracket as a template, drill two 5 mm (13/64 in) holes in the upper mounting holes through the front fascia.
    4. Install the rivets in the upper mounting holes of the license plate bracket.
    5. Using the license plate bracket as a template, drill one 5 mm (13/64 in) hole in the lower mounting hole through the front fascia.
    2. Fig 1: License Bracket Replacement
    GM929440Courtesy of GENERAL MOTORS CORP.
  2. Install the rivet in the lower mounting hole of the license plate bracket.
  3. Position the front license plate to the bracket and install the front license plate retainers.
scientia non olet · About LEMON Manuals